Cisco Nexus 3548 User Manual

505
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show ip route
show ip route
To display routes from the unicast Routing Information Base (RIB), use the show ip route command.
show ip route [all | addr | hostname | prefix | route-type | interface type number | next-hop addr]]
[vrf vrf-name]
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Examples This example shows how to display the route table:
switch(config)# show ip route all
Related Commands
all (Optional) Displays all routes.
addr (Optional) IPv4 address. The format is x.x.x.x.
hostname Hostname. The name can be any case-sensitive, alphanumeric string up to 80
characters.
prefix (Optional) IPv4 prefix. The format is x.x.x.x/length. The length range is from 1 to 32.
route-type (Optional) Type of route. Use ? to see the list of types.
interface type
number
(Optional) Displays the routes for an interface. Use ? to see the supported interfaces.
next-hop addr (Optional) Displays routes with this next-hop address. The format is x.x.x.x.
vrf vrf-name (Optional) Specifies the virtual router context (VRF) name. The name can be any
case-sensitive, alphanumeric string up to 32 characters.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
clear ip route Clears entries in the route table.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back