Cisco Nexus 3548 User Manual

218
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
log-adjacency-changes (OSPF)
log-adjacency-changes (OSPF)
To configure the router to send a syslog message when the state of an Open Shortest Path First (OSPF)
neighbor changes, use the log-adjacency-changes command. To turn off this function, use the no form
of this command.
log adjacency changes [detail]
Syntax Description
Command Default The router sends a system message when the state of an OSPF neighbor changes.
Command Modes Router configuration mode
Router VRF configuration mode
Command History
Usage Guidelines This command is on by default but only reports the up/down (full/down) events if you do not use the
detail keyword.
This command requires the LAN Enterprise Services license.
Examples This example shows how to configure the router to send a system message when an OSPF neighbor state
changes:
switch# configure terminal
switch(config)# router ospf 209
switch(config-router)# log-adjacency-changes detail
switch(config-router)#
Related Commands
detail (Optional) Provides all (DOWN, INIT, 2WAY, EXSTART, EXCHANGE,
LOADING, FULL) adjacency state changes.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
show ip ospf Displays OSPF information.
copy running-config
startup-config
Saves this configuration change to the startup configuration file.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back