Cisco Nexus 3548 User Manual

511
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show routing hash
show routing hash
To display the load-balacning hash information, use the show routing command.
show routing hash [ ipv4 address]
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Usage Guidelines This command is not supported in Warp mode.
Examples This example shows how to display the load-balacning hash information:
switch(config)# show routing hash 4.1.1.2 130.0.0.1
Load-share parameters used for software forwarding:
load-share mode: address source-destination
Universal-id seed: 0x6fe75e69
No IPv4 protocol specified, defaulting to UDP
Invoking pc_ip_ecmp_resolution
Hash for VRF "default"
Hashing to path *Eth1/4%
For route:
130.0.0.0/8, ubest/mbest: 4/0
*via 2.1.1.2, Eth1/2, [1/0], 5d18h, static
*via 3.1.1.2, Eth1/3, [1/0], 5d18h, static
*via 4.1.1.2, Eth1/4, [1/0], 5d18h, static
*via 140.0.0.2, Po2, [1/0], 5d18h, static
Related Commands
ipv4 address Specifies the IPv4 address.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
clear ip route Clears entries in the route table.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back