Cisco Nexus 3548 User Manual

312
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
route-map
route-map
To create a route map, enter the route-map configuration mode, or define the conditions for redistributing
routes from one routing protocol into another, use the route-map command. To delete an entry, use the
no form of this command.
route-map map-tag [deny | permit] [sequence-number]
no route-map map-tag [permit | deny] [sequence-number]
Syntax Description
Command Default The permit keyword is the default.
Command Modes Global configuration mode
Command History
Usage Guidelines If you make changes to a route map that is used by a client, you must exit the route-map configuration
submode before the changes take effect in the client. The route-map changes are not propagated to its
clients until you exit from the route-map configuration submode or 60 seconds expire since entering the
submode.
Use route maps to redistribute routes.
Redistribution
The redistribute router configuration command uses the map-tag name to reference the route map.
Multiple route maps may share the same map tag name.
Use the route-map global configuration command and the match and set route-map configuration
commands to define the conditions for redistributing routes from one routing protocol into another. Each
route-map command has a list of match and set commands associated with it. The match commands
specify the match criteria—the conditions under which redistribution is allowed for the current
route-map command. The set commands specify the set actions—the particular redistribution actions
to perform if the criteria enforced by the match commands are met. The no route-map command deletes
the route map.
map-tag Route map name.
deny (Optional) Specifies that the route or packet is not distributed if the match
criteria are met for the route map.
permit (Optional) Specifies that the route or packet is distributed if the match criteria
for this route are met.
sequence-number (Optional) Number that indicates the position a new route map has in the list
of route maps already configured with the same name. The no form of this
command deletes the position of the route map. Range: 0 to 65535.
Release Modification
5.0(3)A1(1) This command was introduced.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back