Cisco Nexus 3548 User Manual

279
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
platform ip verify address
platform ip verify address
To perform packet verification on IP addresses, use the platform ip verify address command. To return
to the default setting, use the no form of this command.
platform ip verify address {destination zero | identical | reserved | source {broadcast |
multicast}}
no platform ip verify address {destination zero | identical | reserved | source {broadcast |
multicast}}
Syntax Description
Command Default All address tests are enabled.
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to drop broadcast IPv4 packets:
switch# configure terminal
switch(config)# platform ip verify address source broadcast
switch(config)#
Related Commands
destination zero Drops IP packets if the destination IPv4 address is 0.0.0.0.
identical Drops IP packets if the source IPv4 address is identical to the destination
IPv4 address.
reserved Drops IP packets if the IPv4 address is in the 127.x.x.x range.
source Drops IP packets based on the IP source address.
broadcast Drops IP packets if the IP source address is 255.255.255.255.
multicast Drops IP packets if the IPv4 source address is in the 224.x.x.x range.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
platform ip verify Configures IPv4 packet verification checks based on checksum or
fragments.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back