Name: Cisco Nexus 3548
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

295

Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference

OL-27852-01

Chapter Unicast Routing Commands

redistribute (EIGRP)

To inject routes from one routing domain into the Enhanced Interior Gateway Routing Protocol (EIGRP),

use the redistribute command. To remove the redistribute command from the configuration file and

restore the system to its default condition in which the software does not redistribute routes, use the no

form of this command.

redistribute {bgp as-number | direct | eigrp id | ospf instance-tag | rip instance-tag | static}

[route-map map-name]

no redistribute {bgp as-number | direct | eigrp as-number | ospf instance-tag | rip instance-tag |

static}

Syntax Description

Command Default Disabled

Command Modes Address family configuration mode

Router configuration mode

Router VRF configuration mode

Command History

Usage Guidelines You should always use a route map to filter these routes to ensure that EIGRP redistributes only the

routes that you intend to redistribute.

bgp as-number Distributes routes from Border Gateway Protocol (BGP). The

as-number is a 2-byte or 4-byte autonomous system number. The

range for 2-byte numbers is from 1 to 65535. The range for 4-byte

numbers is from 1.0 to 65535.65535.

direct Distributes routes that are directly connected on an interface.

eigrp id Specifies the name of an EIGRP instance. The id can be any

case-sensitive, alphanumeric string up to 20 characters.

ospf instance-tag Distributes routes from the OSPF protocol. This protocol is

supported in the IPv4 address family. The instance-tag can be a

maximum of 20 alphanumeric characters.

rip instance-tag Distributes routes from the RIP protocol. The instance-tag

can be a

maximum of 20 alphanumeric characters.

static Redistributes IP static routes.

route-map map-name (Optional) Specifies the identifier of a configured route map. Use a

route map to filter which routes are redistributed into EIGRP.

Release Modification

5.0(3)A1(1) This command was introduced.

Cisco Nexus 3548 User Manual

Other manuals for Cisco Nexus 3548