Cisco Nexus 3548 User Manual

14
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
address-family (EIGRP)
address-family (EIGRP)
To configure an address family for the Enhanced Interior Gateway Routing Protocol (EIGRP), use the
address-family command. To remove an address family, use the no form of this command.
address-family ipv4 unicast
no address-family ipv4 unicast
Syntax Description
Command Default None
Command Modes Router configuration mode
Address family configuration mode
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to set the IPv4 unicast address family for an EIGRP instance:
switch# configure terminal
switch(config)# router eigrp 201
switch(config-router)# address-family ipv4 unicast
switch(config-router)#
Related Commands
ipv4 Specifies the IPv4 address family.
unicast Specifies unicast address support.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
default-information Controls the distribution of a default route.
default-metric Configures the default metric for routes redistributed into EIGRP.
distance Configures the administrative distance.
maximum-paths Configures the maximum number of equal-cost paths.
redistribute Configures route redistribution for EIGRP.
router-id Configures the router ID.
show ip eigrp Displays EIGRP information.
timers Configures the EIGRP timers.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back