Cisco Nexus 3548 User Manual

424
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show hsrp delay
show hsrp delay
To display the Hot Standby Router Protocol (HSRP) group delay information, use the show hsrp delay
command.
show hsrp delay [interface type number] [group group-number] [all] [brief]
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license but if you want to enable Layer 3 interfaces, you must install
the LAN Base Services license.
Examples This example shows how to display HSRP delay information:
switch# show hsrp delay
Related Commands
interface type
number
(Optional) Specifies the interface type and number for which to display HSRP
information.
group
group-number
(Optional) Specifies the HSRP group number of the interface to display
information about. The range is from 0 to 4095.
all (Optional) Specifies all HSRP information.
brief (Optional) Specifies brief HSRP information.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
delay minimum Configures the delay infromation for HSRP groups.
feature hsrp Enables the HSRP feature.
hsrp delay Configures the delay infromation for HSRP groups.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back