274
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
object
object
To specify an object for a tracked list, use the object command. To remove the object from the tracked
list, use the no form of this command.
object object-number [not] [weight weight-number]
no object object-number
Syntax Description
Command Default None
Command Modes Tracking configuration mode
Command History
Usage Guidelines You can configure an object track list that contains multiple tracked objects. A tracked list contains one
or more objects.
The Boolean expression enables two types of calculation by using either “and” or “or” operators.
You can also configure an object track list that contains a percentage threshold.The percentage of up
objects must exceed the configured track list up percent threshold before the track list is in an up state.
For example, if the tracked list has three objects, and you configure an up threshold of 60 percent, two
of the objects must be in the up state (66 percent of all objects) for the track list to be in the up state.
You can also configure an object track list that contains a weight threshold. A tracked list contains one
or more objects. The combined weight of up objects must exceed the configured track list up weight
threshold before the track list is in an up state. For example, if the tracked list has three objects with the
default weight of 10 each, and you configure an up threshold of 15, two of the objects must be in the up
state (combined weight of 20) for the track list to be in the up state.
This command does not require a license.
Examples This example shows how to configure a track list with an up weight threshold of 30 and a down threshold
of 10:
switch# configure terminal
object-number Tracked object number. The range is from 1 to 500.
not (Optional) Negates the state of an object.
Note You cannot use the not keyword in a weight or percentage
threshold list. You can use this keyword only in a Boolean
list.
weight weight-number (Optional) Specifies a threshold weight for each object.
Release Modification
5.0(3)A1(1) This command was introduced.
To Next Page
Loading...
Need help?
General
