164
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip distribute-list eigrp
ip distribute-list eigrp
To configure a distribution list for the Enhanced Interior Gateway Routing Protocol (EIGRP) on an
interface, use the ip distribute-list eigrp command. To restore the default, use the no form of this
command.
ip distribute-list eigrp instance-tag {prefix-list list-name | route-map map-name} {in | out}
no ip distribute-list eigrp instance-tag {prefix-list list-name | route-map map-name} {in | out}
Syntax Description
Command Default None
Command Modes Interface configuration mode
Command History
Usage Guidelines You must configure the named route map or prefix list to complete this configuration.
This command requires the LAN Base Services license.
Examples This example shows how to configure a route map for all EIGRP routes coming into the interface:
switch# configure terminal
switch(config)# router eigrp 209
switch(config-router)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# ip distribute-list eigrp 209 route-map InputFilter in
switch(config-if)#
Related Commands
instance-tag Name of the EIGRP instance. The instance-tag can be any
case-sensitive, alphanumeric string up to 20 characters.
prefix-list list-name Specifies the name of an IP prefix list to filter EIGRP routes.
route-map map-name Specifies the name of a route map to filter EIGRP routes.
in Applies the route policy to incoming routes.
out Applies the route policy to outgoing routes.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
prefix-list Configures a prefix list.
route-map Configures a route map.
show ip eigrp Displays EIGRP information.