Husqvarna TE 250 2010 Repair Manual

H.40 Part. N. 8000 H1489 (10-2009)
ENGINE REASSEMBLY
Flywheel installation (TC)
Clean ywheel rotor to remove any debris suspended in swirling oil and captured
by the magnets. Fit the tab (1) into the crankshaft and ret the rotor (2).
Hold the rotor (2) to prevent rotation and place an aluminium shim or dummy
gear between the primary drives gears on the right side, again to prevent rotation.
Tighten the nut (3) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17 mm wrench.

Husqvarna TE 250 2010 Specifications

General

Brand	Husqvarna
Model	TE 250 2010
Category	Motorcycle
Language	English