Changing the uid
Brake uid should be checked and changed as per the "Maintenance Chart"
(see Section B), or earlier if contaminated with debris or water.
Do not change brake uid in the rain or with a strong wind.
Use only uid taken from a sealed container (DOT 4). Never reuse
brake uid.
Avoid the ingress of contaminants such as dirt, water, etc. into the
reservoir.
Do not keep the reservoir open without its cover longer than neces-
sary; this would increase the risk of contamination.
Handle the uid with care to avoid damage to painted parts.
Do not mix two brands of uid. This would reduce boil-over point,
leading to loss of braking efciency or degrading of rubber parts.
Replacement procedure is as follows:
- Take the rubber cap off the bleed valve (1) or (1A).
- Attach a clear plastic hose to the calliper bleed valve and place the other end
of the hose in a vessel.
To Next Page
Loading...
Need help?
General
