Page 7.3 - 26 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Digital in- and outputs
7.3.11 Assignment of the inputs
There are two different procedures for the assignment of inputs.
a.) One or several inputs can be assigned to each function. This means an input can be selected at the
single functions (positioning, xed value selection, etc.) which activates this function.
b.) One or several functions can be assigned to each digital input. This means, in parameters di.11...di.22
„Function“ and parameters di.24...di.35 „+ Function“ one or several functions can be assigned to each
single digital input. In parameters di.11...di.22 several functions can be assigned to the respective in-
puts, only one can be selected in parameters di.24...di.35.
Both variants are locked against each other; if an input is assigned to a function, also parameters di.11...di.22
and di.24...di.35 are accordingly adjusted.
Due to the two variants the operation combines two advantages:
- with the functional programming of the inputs, the function's parametrization also permits selecting
which inputs will activate the function,
- the input-related display gives an overview of the complete function of an input and nally it can be
checked if there are undesired function overlappings.
The following table shows a list of the parameters with which the various functions can be assigned digital
inputs:
An. 03 AN1 save trigger / input selection oP.20 Fixed value / input selection 2
An.13 AN2 save trigger / input selection oP.56 Motorpoti increase / input selection
An.23 AN3 save trigger / input selection oP.57 Motorpoti decrease / input selection
cn.11 PID reset / input selection oP.58 Motorpoti Reset / input selection
cn.12 I reset / input selection oP.60 Input selection /clockwise rotation
cn.13 Fade in reset / input selection oP.61 input selection / direction reverse
di.09 Reset / input selection Pn.04 Input selection external error
di.36 Software ST input selection Pn.23 LAD stop / input selection
di.37 Locking ST input selection Pn.29 DC brake / input selection
di.39 disable ST input selection Pn.64 GTR7 / input selection
dr.61 Rs correction auto temp input selection PS.02 Pos/syn / input selection
Ec.48 scan channel 2 input selection PS.03 Shift. slave / input selection
Ec.49 scan channel 1+2 input selection PS.10 Shift. slave inv. / input selection
Ec.50 scan position Ec.60 PS.18 Reference switch / input selection
Ec.51 scan position Ec.61 PS.19 Start reference / input selection
Fr.07 Parameter set / input selection PS.29 Start posi / input selection
Fr.11 Reset set / input selection PS.36 Teach index input selection
LE.17 Timer 1 Start / input selection PS.37 Position scan input selection
LE.19 Timer 1 Reset / input selection PS.38 relative positioning f/r input selection
LE.22 Timer 2 Start / input selection PS.43 Correction reference point
LE.24 Timer 2 Reset / input selection uF.08 Energy saving function / input selection
oP.19 Fixed value / input selection 1 uF.21 Dead time compensation off input selec-
tion
The following table gives an overview of all functions which can be assigned to a digital input with parameters
To Next Page
Loading...
Need help?
General
