BeneVision N1 Patient Monitor Operator’s Manual 3 - 1
3 Getting Started
3.1 Equipment Preparation Safety Information
• Use only installation accessories specified by Mindray.
• Connect only approved devices to this equipment. Devices connected to the equipment must meet
the requirements of the applicable IEC standards (e.g. IEC 60950 safety standards for information
technology equipment and IEC 60601-1 safety standards for medical electrical equipment). The
system configuration must meet the requirements of the IEC 60601-1 medical electrical systems
standard. Any personnel who connect devices to the equipment’s signal input/output port are
responsible for providing evidence that the safety certification of the devices has been performed in
accordance to the IEC 60601-1. If you have any questions, please contact Mindray.
• If it is not evident from the equipment specifications whether a particular combination with other
devices is hazardous, for example, due to summation of leakage currents, please consult the
manufacturer or an expert in the field. A determination must be made that the proposed
combination will not negatively affect the devices themselves or the patient's safety.
• The equipment should be installed by Mindray authorized personnel.
• When disposing of the packaging material, be sure to observe the applicable waste control
regulations and keep it out of children’s reach.
• Before use, verify whether the packages are intact, especially the packages of single use accessories.
In case of any damage, do not apply it to patient.
• Avoid rough handling during transport.
• Put the equipment in a location where it can easily be viewed and operated.
• Keep this manual in the vicinity of the equipment so that it can be conveniently referenced when
needed.
• Save the packing case and packaging material as they can be used if the equipment must be
reshipped.
• Many settings in the patient monitor are password protected. It is recommended to change the
default passwords and keep the passwords safe. Passwords should only be changed by authorized
personnel. Contact your department manager or biomedical engineering department for the
passwords used at your facility.
3.2 Unpacking and Checking
Before unpacking, examine the packaging carefully for signs of damage. If any damage is detected, contact the
carrier or Mindray.
If the packing case is intact, open the package and remove the equipment and accessories carefully. Check all
materials against the packing list and check for any mechanical damage. Contact Mindray in case of any
problems.
• If the N1 purchased contains the internal CO
2
module, connect the CO
2
adapter to the CO
2
receptacle
soon after unpacking the monitor to avoid losing the CO
2
adapter.
To Next Page
Loading...
Need help?
General
