BeneVision N1 Patient Monitor Operator’s Manual 3 - 13
3.11.6 Selecting the Big Numerics Screen
The big numerics screen displays parameter numerics in big font size. You can configure the parameters and
their layout on the big numeric screen. Quickly switch between the normal screen and the big numeric screen
by swiping left or right on the touchscreen with two fingers. You can also select the big numeric screen by
proceeding as follows:
1. Access Choose screen in either of the following ways:
â—† Select the Screen Setup quick key.
◆ Select the Main Menu quick key → from the Display column select Choose screen.
2. Select Big Numerics.
3. Select Big Numerics tab.
4. Select a parameter numeric area or waveform area, and then from the popup list select an element to
display in this area.
3.11.7 Changing Measurement Colors
You can set the color of measurement values and waveforms for each parameter. To do so, follow this procedure:
1. Select Main Menu quick key → from the Parameters column select Parameter Color.
2. Select the Current tab and set the colors of the currently monitoring measurement values and waveforms.
3. Select the All tab and set the colors of measurement values and waveforms for all parameters.
3.12 Disconnecting the Wireless Network
To disconnect the wireless network manually, follow this procedure:
1. Swipe the screen from top down with a single finger.
2. Select
.
To reconnect the wireless network after it is disconnected manually, follow this procedure:
1. Swipe the screen from top down with a single finger.
2. Select
3.13 Turning Off the Monitor
Before turning off the monitor, perform the following check:
1. Ensure that monitoring of the patient has been completed.
2. Disconnect the cables and sensors from the patient.
3. Save or clear the patient data as required.
To turn off the monitor, press and hold the power switch for 3 seconds.
• Press and hold the power switch for no less than 10 seconds to forcibly shut down the monitor if it
could not be shut down normally. This may cause loss of patient data.
• Turning off the monitor does not disconnect the monitor form the AC mains. To completely
disconnect the power supply, unplug the power cord.
• In case of a temporary power failure, if the power is restored within 30 minutes, monitoring will
resume with all active settings unchanged. If the monitor is without power for more than 30
minutes, it behaves the same as if it were normally turned off.
To Next Page
Loading...
Need help?
General
