9-7-4
Troubleshooting
This section explains possible error messages that may be displayed while using Configuration Copy,
as well as possible solutions.
l
Errors that may occur when loading.
During the loading of a sensor controller’s project, the following error message is displayed.
Example: Loading of settings data file failed.
• To continue the loading of the Sensor Controller's project
Click Continue button.
Loading of the sensor controller will continue, however, the settings data that caused the error
message to display will not be applied.
• To cancel the loading of the sensor controller's project
Click Interrupt button.
Loading of the sensor controller will stop. After stopping, you can refer to the troubleshooting list
to find the possible cause and solution for the problem.
After that, initialize the sensor controller, and then reload the sensor controller's project.
A list of some common errors that may occur when using the Configuration Copy tool.
Problem Cause Action
An error message occurred be-
cause the Sensor Controller's
project cannot be saved.
Save destination is not set. Set the save destination.
Name of the Sensor Controller's
project is not entered.
Enter the Sensor Controller
project name.
An empty capacity of the external
storage is insufficient.
• Change to an external storage
device with larger memory ca-
pacity.
• Delete the unnecessary files.
9 Saving/Loading Data
9 - 30
FH/FHV Series Vision System User’s Manual (Z365-E1)
To Next Page
Loading...
Need help?
General
