7 Set the IP address for the Sensor Controller on the Network setting.
8
Click OK.
The IP address is set to the Sensor Controller.
9 On the network reference list, click Refresh to check the IP address setting is reflected.
Precautions for Correct Use
The reflection of IP address settings may take time. If it were not reflected, click Refresh again.
Precautions for Correct Use
If a bad IP address or an IP address overlapped with a device on the same network are set, an
IP address different from your Setting will be displayed on the list like (169.254. xx. xx). Perform
this procedure to set a valid IP address.
10-1-2
Connection Method for Remote Operation
Precautions for Correct Use
If Ethernet cables are broken during the remote operation, Remote Operation Tool and the Sen-
sor Controller may be improperly operated.
After terminating the Remote Operation Tool return the Sensor Controller to the normal state
using Restart or Initialize buttons on the Remote Operation Tool.
If the Remote Operation Tool cannot be terminated with End in the file menu, terminate the
process of FZ-PanDA.exe from the task manager.
10 Advanced Usage
10 - 9
FH/FHV Series Vision System User’s Manual (Z365-E1)
10-1 Remotely Operating the
Controller [Remote Operation]
10
10-1-2 Connection Method for Remote Operation
To Next Page
Loading...
Need help?
General
