3-4
Checking the Memory Consumption
and Percentage of Memory Used
The Memory state window that shows the memory used in the sensor controller can be opened from
the Measurement Manager Bar. For the FHV series, open the Memory state window from the system
information window. Refer to 3-3 Checking System Information [System Information] on page 3 - 24.
1 Click the M button on the Measurement Manager Bar of the Main Window.
2 The Memory state window is displayed. You can check the amount of memory used.
For details of the Memory state window, refer to the following.
Refer to 3-3 Checking System Information [System Information] on page 3 - 24.
FH/FHV series
Additional Information
If the amount of used memory increases and the amount of free memory becomes insufficient,
it may cause errors in operation mode switching or in adding Processing Units into the meas-
urement flow. Please check the memory consumption when you create scenes.
For details, refer to 3-3 Checking System Information [System Information] on page 3 - 24.
3 Basic Operations
3 - 28
FH/FHV Series Vision System User’s Manual (Z365-E1)
To Next Page
Loading...
Need help?
General
