Parker Compax3 Series User Manual

Parker EME
Setting up Compax3
192-120114 N5 C3I22T11 June 2008 247
or
 by directly entering under optimization: Analog Input
4.3.8.1 Signal processing of the analog inputs
171.3
171.2
171.2
+
171.4
X11/10+
X11/2-
Actual
value
monitoring
Analog 1
685.4
685.3
170.3
170.2
170.2
+
170.4
X11/9 +
X11/11-
Actual
value
monitoring
Analog 0
B:
Continuative structure image (see page 237)
4.3.8.2 Offset alignment
Performing an offset alignment when working with the ±10V analog interface in the
optimization window under optimization: Analog input Offset [170.4].
Enter the offset value for 0V input voltage.
The currently entered value is shown in the status value "analog input" (optimizing
window at the top right) (unit: 1 ≡ 10V). Enter this value directly with the same sign
as offset value.
The status value "analogue input" shows the corrected value.
4.3.8.3 Gain alignment
Performing an offset alignment when working with the ±10V analog interface in the
optimization window under optimization: Analog Input: Gain [170.2].
A gain factor of 1 has been entered as default value.
The currently entered value is shown in the status value ”analogue input” (optimi-
sing window at the top right).
The status value "analogue input" shows the corrected value.

Parker Compax3 Series Specifications

General

Brand	Parker
Model	Compax3 Series
Category	DC Drives
Language	English