1126700 SmartPAC 2 User Manual
4-22 Initialization Mode
5. When the Alphabetic Entry window (see Figure 4-5, page 4-8) displays, key in a custom
name of up to 12 characters, following the directions on the screen, then press F6 to accept
your entry. You are returned to the Tool Information Setup screen with your custom name
displayed. To cancel your selection, press RESET.
6. Highlight the UNS 1 item, and press ENTER. The Tool Information Units Selection
screen, shown in Figure 4-17, displays.
7. Move the highlight bar to the abbreviation for the unit you want, using the cursor keys,
and press ENTER. (See Table 4-3, page 4-23 for an explanation of abbreviations.) You
are returned to the Tool Information Setup screen with your Units selection displayed.
8. If you want to specify a unit that is not in the list, select the “CUSTOM” item. When the
Alphabetic Entry window displays, key in a unit of up to 6 characters. To accept your
entry, press F6. You are returned to the Tool Information Setup screen with the unit you
created displayed.
You can use a separate computer keyboard to enter tool information names. See
page 4-45.
Figure 4-17. Tool Information Units Selection Screen
To Next Page
Loading...
Need help?
General
