Wintriss SmartPAC2 User Manual

SmartPAC 2 User Manual 1126700
Initialization Mode 4-25
For most items on the Security Access Menu, you can specify three types of access:
• PROGRAM AND RUN MODES. Allows users to change settings in both Program and
Run modes. This access type is the least secure.
• PROGRAM MODE ONLY. Allows users to change settings only in Program mode (i.e.,
when the Program/Run key is in the PROG position). To prevent users from entering
Program mode, you should remove the Program/Run key with the switch in the RUN
position.
• PASSWORD REQUIRED. Allows users to change settings only after they have entered a
password. This access type is the most secure.
The following items on the Security Access Menu allow you to select other access options
(see Table 4-5 for a complete list of security access settings):
• CHANGE COUNTS and CHG GOOD PRTS CNT. These items allow you to specify NO
CHANGES ALLOWED, which prevents changes to actual counter values for strokes, good
parts, total hits, and batch counters (CHG COUNTS) or for good parts only (CHG GOOD
PRTS CNT). This setting is applicable in either Program or Run mode.
• INIT. PASSWORD. This item allows you to require a password for user access to the Main
Initialization Menu. To require a password, select MUST BE USED. Otherwise, select
NOT REQUIRED.
• LOAD MONITOR. This item has four options: ALLOW RECALC/ADJUST, ALLOW
RECALC ONLY, NO RECALC/ADJUST, and PASSWORD REQUIRED.
• CHG TOOL TEMPLATE. This item has two options: PASSWORD REQUIRED and
PASSWORD NOT REQUIRED.
Table 4-5. Security Access Settings
Optional modules included; your menu may be different
Security Access Menu Item Security Access Settings
LOAD TOOL # PROGRAM AND RUN MODES
PROGRAM MODE ONLY
PASSWORD REQUIRED
DELETE TOOL # PROGRAM MODE
NOT ALLOWED
PASSWORD REQUIRED
SET CNTR PRESET PROGRAM AND RUN MODES
PROGRAM MODE ONLY
PASSWORD REQUIRED
CHANGE COUNTS PROGRAM AND RUN MODES
PROGRAM MODE ONLY
PASSWORD REQUIRED
NO CHANGES ALLOWED
CHG GOOD PRTS CNT PROGRAM AND RUN MODES
PROGRAM MODE ONLY
PASSWORD REQUIRED
NO CHANGES ALLOWED
RESET MODE PROGRAM AND RUN MODES
PROGRAM MODE ONLY
PASSWORD REQUIRED

Wintriss SmartPAC2 Specifications

General

Brand	Wintriss
Model	SmartPAC2
Category	Controller
Language	English