SmartPAC 2 User Manual 1126700
Initialization Mode 4-31
3. To begin the backup process, press the F6 (Backup) function key.
The message
Please wait...
appears briefly at the top of the screen, and the following message displays near the
bottom
USB Disk Detected (nnn Meg free)
where nnn is the amount of disk space in megabytes available for storing backup
information.
Figure 4-23. Backup/Restore Control Menu
If the SmartPAC 2 detects that the USB disk does not have enough free space to store the
tool and initialization backup information, a message like the following displays:
There is NOT enough space available
on USB Disk!
Please remove and free up approx
nnn.nK then try again
Press RESET to clear this message
The variable nnn.n is the number of kilobytes (KB) of free space required for the backup.
Press RESET to clear the message, then remove the USB disk, install another USB disk
with the required amount of free space, and press F6 (Backup) again.
If you want to re-use the original USB disk, you can insert it into a USB connector on your
computer, delete the files necessary to free up the required amount of space, re-install it in
the SmartPAC 2, and reinitiate the backup.
To Next Page
Loading...
Need help?
General
