SmartPAC 2 User Manual 1126700
Initialization Mode 4-27
Information about accessing menus in Program and Run modes is provided in chapters 5 and
6.
Setting Security Access
Figure 4-20. “Enter Your Password” Screen
IF YOU FORGET OR DO NOT KNOW YOUR PASSWORD(S)
Call Wintriss Tech. Support at the telephone number on the cover of this manual. Give the Tech.
Support person the 5-digit number from the bottom of the “Enter your password” display.
CHECK YOUR PASSWORDS
Make sure to check your passwords before changing any security access settings. Record the
passwords in a safe place. Refer to Changing Passwords, page 4-28.
DO NOT ENABLE INIT. PASSWORD UNTIL YOU HAVE CHECKED YOUR PASSWORDS
Field upgraded SmartPAC 2s may have different passwords than those listed in this manual. If
you do not know the Initialization password and change the INIT. PASSWORD item to MUST BE
USED, you will not be able to access the Main Initialization Menu.
BE CAREFUL WHEN SETTING RESET MODE SECURITY ACCESS
If you select the PROGRAM MODE ONLY or PASSWORD REQUIRED setting for the RESET
MODE item, the operator will not be able to reset SmartPAC 2 in Run mode when the press stops
as the result of a malfunction.
If you want the operator to be able to reset the machine in Run mode following errors, select
PROGRAM AND RUN MODES as the Reset Mode setting.
If you want one person to be responsible for tracking faults, give that individual the Program/Run
key, and set Reset Mode access to PROGRAM MODE ONLY. When a fault occurs, that individual
can reset the press by turning the key switch to PROG and pressing the RESET key, then resume
press operation by turning the key back to RUN.
WHEN DONE. PRESS RESET TO
60599
Give this number to
Wintriss Tech Support if
you forget your password.
Note:
Your number may be
different.
To Next Page
Loading...
Need help?
General
