Wintriss SmartPAC2 - Index

Index I-1
Index
–A–
AC wiring
connecting to SmartPAC 2
,2-14
grounding,2-15
running in conduit,2-14
alerts (preventive maintenance)
clearing
,A-14
setting conditions for,A-10
viewing,A-13
alphanumeric tool numbers, setting,4-5
angle wheel rotation, setting,4-4
auto advance
calculating the auto advance constant
,4-14
setting on/off angles for cam channels
programmed as auto advance
,5-44
setting the auto advance constant,4-14
auto enable
setting the auto enable by sensor counter
,5-23
setting the auto enable by tool counter,5-21
–B–
backup (tool and initialization data),
performing
,4-29
batch counters. See also counters
setting increment mode
,5-13
setting output mode,5-13
Board,2-13
board (SmartPAC 2), installing replacement,E-1
board layouts
Cam Output
,2-27
DiProPAC,2-20
DiProPAC installed on SmartPAC 2 board,2-19
ProCamPAC,2-20
ProCamPAC installed on SmartPAC 2
board
,2-19
SmartPAC 2,2-13
brake monitor
adjusting parameters
,6-19
faults,7-3
responding to brake warning LED,7-1
setting parameters,4-8
brake warning LED
location on SmartPAC 2 front panel
,1-3
responding to,7-1
–C–
cam channels
adjusting programmed settings
,6-17
deleting settings,5-46
making an auto advance setting,5-44
naming,4-11
programming,5-37
programming a DSV on delay time,5-45
programming a timed output setting,5-42
programming an on/off setting,5-39
programming multiple on/off settings,5-40
setting global cams,4-16
testing,2-42
viewing cam timing,6-17
viewing the cam summary, 5-46, 6-19
viewing the global cam summary, 5-47, 6-18
cam output assembly. See ProCamPAC output
assembly
cam output relays. See relays, cam output
checkout tests, performing
,2-41
CLEAR key (SmartPAC 2), using,3-4
clock, setting,4-41
communications
faults
,7-11
performing a loopback test,4-40
setting parameters for Wintriss data collection
software
,4-33, F-7, G-7
verifying,4-39
viewing transmit and receive data,4-40
counters
adjusting good parts count for reporting to
LETS
,G-23
adjusting good parts count for reporting to
SFC
,F-25
adjusting in Program mode,5-11
adjusting in Run mode,6-7
clearing the total hits counter,5-12
entering preset values,5-11
entering scrap counts for reporting to
LETS
,G-20
entering scrap counts for reporting to SFC,F-23
preset reached messages,7-2
programming,5-9
resetting batch counters,6-8
setting batch pre-load counts,5-15
setting increment angle,5-14
setting increment mode for batch counters,5-13
setting output mode for batch counters,5-13
setting parts per stroke or strokes per part,5-14
setting the auto enable by sensor counter,5-23
setting the auto enable by tool counter,5-21
setting the strokes counter for a green special
sensor
,5-29
crank angle clock
setting cam channel timing on
, 5-40, 5-43, 5-44
setting green sensor ready signal on,5-28
setting rotational direction,4-4
critical angle, setting for a sensor set to smart
stop
,5-26