Furuno TZT9 - How to Measure the Range and Bearing between Two Targets; How to Off-Center the Picture; Heading Line

6. RADAR
6-10
6.9 How to Measure the Range and Bearing Between
Two Targets
You can measure the range and bearing between any two targets with the [Measure]
menu.
1. Select the center of the target A to display the pop-up menu.
2. Select [Measure].
3. Select the center of the target B. A dashed line runs between the target A and the
target B. The range and bearing between the targets A and B are shown.
4. Select [Cancel Ruler] at the top right-hand corner of the screen to erase the indi-
cation.
6.10 How to Off-center the Picture
You can off-center your position to expand the view field without selecting a larger
range scale. The position can be off-centered in the bow, stern, port or starboard di-
rection, but not more than 75% of the range in use.
Pan the radar display by dragging with a finger. To return your ship to the center of the
screen, select [Center Radar] at the top right-hand corner of the screen.
6.11 Heading Line
The heading line indicates your heading in all orientation modes. This line connects
between your position to the outer edge of the radar display. The line is at zero de-
grees on the bearing scale in the head-up mode. The orientation of the line changes
in the north-up mode with the movement of your ship. If it is hard to identify the echoes
on the heading line, you can hide the heading line and range rings for a few seconds.
Select [Hdg Ln Off] from the RotoKey menu to activate this function.
Target A
Target B
Range and bearing
M: Magnetic
0.876NM
76.4°M
0.876NM
76.4°M
Normal picture
Picture off-centered in stern direction
30
40
50
60
70
80
90
100
110
120
130
140
150
210
220
230
240
250
260
270
280
290
300
310
320
330
0
10
20
30
40
50
60
70
80
90
100
110
250
260
270
280
290
300
310
320
330
340
350