Furuno TZT9 User Manual

10. CAMERA/VIDEO/FUSION-Link
10-2
10.3 How to Set the Video Display
10.3.1 How to select the input source
Select the input source from the RotoKey menu (see section 10.6).
[Analog 1 (2)]: An analog signal
[IP 1 (2, 3, 4)]: A digital signal
[Quad]: All digital signals (maximum of four) from an axis server
[Input 1 (2, 3, 4)]: A digital signal from an axis server
[Quad 2]: All digital signals (maximum of four) from second axis server
[Input 1 (2, 3, 4)]: A digital signal from second axis server
Note: The default menu names are replaced with the nicknames set in the [Camera]
menu. See paragraph 10.3.2.
10.3.2 How to set each video signal
Analog camera
You can select video format for an analog camera and change its nickname. Select
[Camera] - [Analog Camera 1] (or 2) of the main menu.
[Video Format]: Select the video format from [PAL] or [NTSC].
Note: The power must be reset to apply the setting. After you change the setting, the
following message appears.
Select [Yes] to reset the power and apply the setting immediately, or select [No] to ap-
ply the setting at the next power on. The menu shows the new setting ([PAL] or
[NTSC]) but change is not effected until the power is reset.
[NickName]: Enter (or change) the nickname (a maximum of 13 alphanumeric charac-
ters) with the software keyboard then select [Confirm].
Analog Camera 1
Camera 1
Video Format NTSC
NickName
PAL
NTSC
Video Format
NTSC
Application have to restart now !
Do you want to restart application
?
Yes
No

Furuno TZT9 Specifications

General

Brand	Furuno
Model	TZT9
Category	Monitor
Language	English