6. RADAR
6-22
6.28 FAR-2xx7 Radar Series and NavNet TZtouch
The FAR-2xx7 radar series* can be connected to your NavNet TZtouch, and some
functions can be controlled from the NavNet TZtouch. The table below shows which
features can be controlled from the NavNet TZtouch. Note that you should turn off
Guard Polygon at the radar to control the radar from the NavNet TZtouch.
*: B type, and IMO type program no. 02.50 or before and 3.13 or later.
Function
Controllable
from NavNet
Remarks
AIS data (LAN) No
AIS data (NMEA 0183) No
AIS data display Yes
ARPA acquisition, cancellation Yes
Auto Gain No
Auto Rain No
Auto Sea Yes Value of Auto Sea is “0”.
Automatic ARPA target acquisition No
Dual range mode No
Echo average No
Gain Yes Manual only.
Installation setting (tuning,
antenna rotation speed, etc.)
No
Manual ARPA target
acquisition, cancel
Yes Max no. of targets is 100.
Position, time data Yes Shared via LAN
Range scale Yes 0.0625, 1, 2, 4, 8, 16, 32, 36,
64, 72, 120 not available with
IMO type. 72 nm not available
with B type.
Selection of range unit No Fixed at “NM”.
Source selection, picture display Yes
TX/STBY Yes
Watchman No
To Next Page
Loading...
Need help?
General