2. CHART PLOTTER
2-13
3. Select [Speed Alarm Value] to display the software keyboard.
4. Set the value for [Under] or [Over] then select [Confirm].
5. If you output the speed alarm from this equipment, select the [ON] icon in [Speed
Alarm Output].
6. Select [Close].
2.10.5 Anchor watch alarm
The anchor watch alarm tells you that your ship has moved a distance greater than
the set value when the ship must not be moving.
1. Select the [ON] icon in [Anchor Watch Alarm] of the [Alarm] menu.
2. Select [Anchor Watch Alarm Value] to display the software keyboard.
3. Set the value then select [Confirm].
4. Select [Close].
2.10.6 Alarm menus
The followings are the alarm menus not previously mentioned.
[Hardware Alarm]: Select [OFF] to disable hardware alarms.
[Notification Sound]: Activate ([Sound 1 (2, 3)]) or deactivate ([Off]) the notification
sound (for "Waypoint Crossing" (see section 5.8), "End of Route" (section 4.11) or fish
finder alarms (section 7.9)).
Your ship's position where you
start the anchor watch alarm.
Alarm
setting
: Alarm area
Off
Sound 1
Sound 2
Sound 3
Notification Sound
Sound 1
To Next Page
Loading...
Need help?
General