Furuno TZT9 User Manual

8. MULTI BEAM SONAR DFF-3D
8-4
8.2 Multi-Sounder Display Operations
This section covers the functions available with the multi-sounder display. For the
menu items shared with the conventional fish finder, see chapter 7.
8.2.1 How to switch between TX and STBY
Tap the multi-sounder display to show the pop-up menu. Select [TX] to start transmit-
ting. [ST-BY] appears at the center of the screen when transmission is stopped.
8.2.2 How to switch between single beam and triple beam presenta-
tions
1. Tap the multi-sounder display to show the pop-up menu.
2. Select [Mode].
3. Select [Single Beam] or [Triple Beam] as required.
4. Select [Close] to close the pop-up menu.
8.2.3 How to set the TX beam angle
You can set the TX beam angle for the port, starboard and downward beams.
1. Tap the multi-sounder display to show the pop-up menu.
2. Select [Beam Angle].
3. Set the beam angle as required.
8.2.4 How to set the TX beam width
You can set the TX beam width for the port, starboard and downward beams.
1. Tap the multi-sounder display to show the pop-up menu.
2. Select [Beam Width].
3. Set the beam width as required.
8.2.5 How to show or hide the scale box
The scale box, shown at the bottom left corner on the display, shows depth, current
range, and TX frequency. You can show the box as follows.
1. Tap the multi-sounder display to show the pop-up menu.
2. Select [Scale Box] to show the scale box.

Furuno TZT9 Specifications

General

Brand	Furuno
Model	TZT9
Category	Monitor
Language	English