Tektronix MSO58 User Manual

Command groups
Table 2-31: Measurement commands (cont.)
Command
Description
MEASUrement:CLOCKRecovery:ADVanced:
METHod
This command sets or queries the global advanced clock recovery method.
MEASUrement:CLOCKRecovery:
CLOCKFrequency
This command sets or queries the global clock frequency used for fi xed constant
clock recovery.
MEASUrement:CLOCKRecovery:
CLOCKMultiplier
This command sets or queries the global clock multiplier used for explicit clock
recovery.
MEASUrement:CLOCKRecovery:
CONSTCLOCKM OD e
This command sets or queries the global constant clock mode used for constant
clock recovery.
MEASUrement:CLOCKRecovery:DAMPing This command sets or queries the global damping value used for PLL clock recovery.
MEASUrement:CLOCKRecovery:DATAPath This command sets or queries the global file containing the data pattern used for
known data pattern clock recovery.
MEASUrement:CLOCKRecovery:DATARate This command sets or queries the global nominal data bit rate used for nominal data
rate clock recovery.
MEASUrement:CLOCKRecovery:
EXPLICITCLOCKMODe
This command sets or queries the global explicit clock mode used for explicit clock
recovery.
MEASUrement:CLOCKRecovery:JTFBandwidth This command sets or queries the global JTF bandwidth used for PLL clock recovery.
MEASUrement:CLOCKRecovery:
LOOPBandwidth
This command sets or queries the global loop bandwidth used for PLL clock recovery.
MEASUrement:CLOCKRecovery:
MEANAUTOCalculate
This command sets or queries how often the clock is calculated for constant clock
recovery.
MEASUrement:CLOCKRecovery:METHod
This command sets or queries the global clock recovery method.
MEASUrement:CLOCKRecovery:MODel This command sets or queries the global PLL clock recovery model used for PLL
clock recovery.
MEASUrement:CLOCKRecovery:
NOMINALOFFset
This command sets or queries the global offset value used for explicit clock recovery.
MEASUrement:CLOCKRecovery:
NOMINALOFFset:SELECTIONtype
This command sets or queries the global offset type used for explicit clock recovery.
MEASUrement:CLOCKRecovery:STAndard This command sets or queries the global communications standard used for PL L
clock recovery.
MEASUrement:DELete The command deletes the specified measurement.
MEASUrement:DIRacmodel This command sets or queries the dirac model used to separate random from
deterministic jitter for jitter measurements.
MEASUrement:DISPLAYUnits This command sets or queries the display units used for jitter summary measurements.
MEASUrement:EDGE<x> Sets o r queries the type of the edge for the measurement.
MEASUrement:EYERENDER This command sets or queries the state of high-performance eye rendering for an
eye diagram.
MEASUrement:FILTers:BLANKingtime This command sets or queries the global filter blanking time.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-41

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English