xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
156
IPv6 Route Table
This window is used to display the current IPv6 routing table.
To view the following window, click L3 Features > IPv6 Route Table, as show below:
Figure 5-4 IPv6 Route Table window
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix
Tick the check box and enter the IPv6 destination network address of the route.
Tick the check box and enter the IPv6 address.
Tick the check box to display the RIPng route entries.
Tick the check box to display the OSPFv3 route entries.
Hardware
Tick the check box to display the route entries which have been written into
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Policy Route Settings
This window is used to create a policy route and define the rule’s name.
To view the following window, click L3 Features > Policy Route Settings, as show below:
Figure 5-5 Policy Route Settings window
The fields that can be configured are described below:
Parameter Description
Enter the policy route name. The maximum length is 32 characters.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the Edit button to see the following window.
To Next Page
Loading...
Need help?
General