xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
355
JWAC Port Settings
This window is used to configure JWAC port settings for the Switch.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Port Settings as
shown below:
Figure 8-43 JWAC Port Settings Window
The fields that can be configured are described below:
Parameter Description
Unit
Select the unit you want to configure.
From Port / To Port
Use the drop-down menus to select a range of ports to be enabled as JWAC ports.
State
Use this drop-down menu to enable the configured ports as JWAC ports.
Max Authenticating
Host (0-100)
Enter the maximum number of host process authentication attempts allowed on each
port at the same time. The default value is 100.
Aging Time (1-1440)
Enter the time period during which an authenticated host will remain in the
authenticated state. Tick the Infinite check box to never age out the authenticated host
on the port. The default value is 1440.
Block Time (0-300)
Enter the period of time that a host will be blocked if it fails to pass authentication. The
default value is 60.
Idle Time (1-1440)
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. The default value is Infinite. To change this value, un-tick the
Infinite check box and enter a value between 1 and 1440 minute(s). Tick the Infinite
check box to indicate the Idle state of the authenticated host on the port will never be
checked.
To Next Page
Loading...
Need help?
General