xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
407
DNS Resolver Dynamic Host Name Table
This window displays the current host name entries.
To view this window, click Network Application > DNS Resolver > DNS Resolver Dynamic Host Name Table as
shown below:
Figure 9-31 DNS Resolver Dynamic Host Name Table window
RCP Server Settings
This window is used to configure global RCP server information. This global RCP Server setting can be used when
the Server or remote user name is not specified. Only ONE RCP server can be configured per system. If user does
not specify the RCP Server in the CLI command, and global RCP Server was not configured, the Switch will ask
user to input the Server IP address or remote user name while executing the RCP commands.
To view this window, click Network Application > RCP Server Settings as shown below:
Figure 9-32 RCP Server Settings Window
The fields that can be configured are described below:
Parameter Description
IP Address
The IP address of global RCP Server. By default, the server is unspecified.
User Name
The remote user name for logon into global RCP Server. By default, global server’s remote
user name is unspecified.
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
SNTP
The Simple Network Time Protocol (SNTP) is a protocol for synchronizing computer clocks through the Internet. It
provides comprehensive mechanisms to access national time and frequency dissemination services, organize the
SNTP subnet of servers and clients, and adjust the system clock in each participant.
SNTP Settings
Users can configure the time settings for the Switch.
To view this window, click Network Application > SNTP > SNTP Settings as shown below:
To Next Page
Loading...
Need help?
General