xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
333
Set the RADIUS server retransmit time, in times.
Set the key the same as that of the RADIUS server.
Confirm the key the same as that of the RADIUS server.
Click the Apply button to accept the changes made.
RADIUS Accounting Settings
Users can configure the state of the specified RADIUS accounting service.
To view this window, click Security > RADIUS > RADIUS Accounting Settings as shown below:
Figure 8-23 RADIUS Accounting Settings window
The fields that can be configured are described below:
Parameter Description
Network
When enabled, the Switch will send informational packets to a remote RADIUS server
when 802.1X and WAC port access control events occur on the Switch.
Shell
When enabled, the Switch will send informational packets to a remote RADIUS server
when a user either logs in, logs out or times out on the Switch, using the console, Telnet,
System
When enabled, the Switch will send informational packets to a remote RADIUS server
when system events occur on the Switch, such as a system reset or system boot.
Click the Apply button to accept the changes made.
RADIUS Authentication
Users can display information concerning the activity of the RADIUS authentication client on the client side of the
RADIUS authentication protocol.
To view this window, click Security > RADIUS > RADIUS Authentication as shown below:
To Next Page
Loading...
Need help?
General