Husky Altanium Matrix5 User Manual

v 1.0 — February 2020 Altanium Matrix5
128 Energy Usage and Units
To enable the No Heater Detection feature, do the steps that follow:
1. On the System Setup screen, touch the Heats Setup tab and then the Monitoring 2 tab.
2. Touch the No Heater Detected Enable check box below No Heater Detection, so the
check mark shows.
10.15 Energy Usage and Units
Energy accumulation data is updated every three seconds and shown in real time to the user
on the Energy Display screen. Users can set the Energy Cost Rate (Kwh) and Currency Type.
To change the energy usage and units, do the steps that follow:
1. Touch the Energy Display button on the Home screen.
The Energy Display screen shows. Refer to Figure 10-11.
2. Touch the Energy Cost Rate (Kwh) field below Energy Usage and Units.
3. Enter the kWh cost rate and touch the Accept button.
4. Touch the Currency Type button field below Energy Usage and Units.
5. Touch the currency type from the list.
Figure 10-11 Energy Display Screen

Husky Altanium Matrix5 Specifications

General

Brand	Husky
Model	Altanium Matrix5
Category	Controller
Language	English