Husky Altanium Matrix5 User Manual

Make a New Mold Setup Folder 47
User Guide v 1.0 — February 2020 Mold Setups
6.1.1 Make a New Mold Setup Folder
Use a mold setup folder to store multiple mold setup files.
To create a new Mold Setup folder, do the following:
1. Touch the New Folder button.
2. Enter the name of the new mold folder.
3. Touch the Accept button.
The new mold setup folder now shows below the Molds directory.
Touch the Discard Changes button to set the loaded mold setup file back
to the state after it was last saved (with the Save Mold Setup button). All
unsaved changes are discarded. This operation only has an effect on the
loaded mold setup file, regardless of what is selected on the screen.
Touch the Copy button to copy mold setups, images, or documents from
one folder or device.
Touch the Paste button to paste mold setups, images, documents, or
notes that were copied from one folder or device into a different folder.
Touch the Delete button to delete a mold folder, mold setup, image, or
document. A message is shown to make sure you want to complete the
operation. This button is not available unless a folder or file is selected.
Touch the Rename button to open the screen keyboard to rename a mold
folder, mold setup, image, note, or document. This button is not enabled
unless a file or folder is selected.
Touch the Preview button to see a View window of the mold setup files,
images, notes, and documents.
Touch the Cancel button to cancel the file copy.
Table 6-2 Mold Setup Screen Button Descriptions (Continued)
Button Description

Husky Altanium Matrix5 Specifications

General

Brand	Husky
Model	Altanium Matrix5
Category	Controller
Language	English