Husky Altanium Matrix5 User Manual

User Guide v 1.0 — February 2020 Maintenance
Matrix5 System 195
Chapter 15 Maintenance
This chapter describes the maintenance tasks necessary to maintain the Altanium Matrix5
system.
At intervals and before you energize the equipment, do a check of all cables and cable
connections to make sure that there is no wear or damage. Do not operate equipment if the
cables are damaged. Replace cables that are damaged.
The maintenance procedures that follow can be done only when necessary.
15.1 Matrix5 System
Two primary components of the Matrix5 systems are serviceable:
• X-Series or H-Series intelligent control cards (ICC)s
• Matrix5 operator interface
The Altanium operator interface display module is used to enter and display molding
parameters. Refer to Figure 15-1. Before doing maintenance on the Matrix5 system, always
de-energize the system at the Altanium main power switch. Refer to Figure 15-2. Do the lock
out and tag the Altanium main power switch in accordance with local codes.
Procedure Reference
Replace an Intelligent Control Card (ICC
2
or ICC
3
) Section 15.3.1
Replace an Open Fuse on an Intelligent Control Card (ICC
2
or ICC
3
) Section 15.3.2
Remove and Replace the Touch Monitor Section 15.4.1
Remove and Replace the MCU Section 15.4.2
Remove and Replace the Operator Interface Section 15.4.3
Install the Remote Operator Interface Section 15.4.4
Install the Alternative Mounted Operator Interface Section 15.4.5
Install the Dual Touch Monitor Section 15.4.6
Calibrate the Thermocouple Inputs Section 15.5
Clean the System Section 15.6

Husky Altanium Matrix5 Specifications

General

Brand	Husky
Model	Altanium Matrix5
Category	Controller
Language	English