Global Settings 165
User Guide v 1.0 — February 2020 Data Recording
4. Touch the Threshold field and enter the number of times that a value must be outside
of the lower and upper limit before Out of Specification Action starts.
5. Touch the Accept button.
6. To enable the Target Settings, touch the Use Limits field and select Yes.
7. If you want to set these Target Settings critical, touch the Critical field and select Yes.
8. If you want to activate the Process Outside Limit (Digital Output 6) signal during an out
of limit condition, touch the Process Outside Limits check box, so the check mark
shows.
12.3.2 Global Settings
In the Global Settings area you can set a Critical Variable Action for the heats and/or servos
that are installed on your system. For heats, the selections are No Reaction or Stop Heats. For
servos, the selections are No Reaction or Stop End of Cycle.
To set a Critical Variable Action, do the steps that follow:
1. On the process Limits screen, touch the Heats or Servos field.
2. Select the action you want for the heats or servos.
12.3.3 Delay Limit Check
If you want the Altanium controller to wait a specified time or number of cycles before the
system does the limit check, those parameters can be set in the Delay Limit Check area.
To set the heats parameter, do the steps that follow:
1. On the process Limits screen, touch the Heats Limit field and enter the number of
seconds for the delay (1 to 900 seconds).
2. Touch the Accept button.
To set the servos parameter, do the steps that follow:
1. On the process Limits screen, touch the Servos Limit field and enter the number of
cycles for the delay (1 to 999 cycles).
2. Touch the Accept button.
To Next Page
Loading...
Need help?
General
