v 1.0 — February 2020 Altanium Matrix5
42 User Preferences
5.1.3 User Preferences
If a user is logged onto the system and makes changes to the unit of measurement or
language selection, these values will be saved to that user’s profile after logout and will be
recalled the next time the same user logs in again.
5.1.4 Auto Logout
A system-wide timer will log the user off if there is no touch screen activity within a specified
timeout period. The default setting is five minutes. The minimum value is 10 seconds.
To change the auto logout timeout period, do the steps that follow:
1. Log in with Administrator privileges.
2. On the Home screen, touch the System Setup button and then the User Management
tab.
3. Touch the Auto Logout Time field and enter the desired time value in the dialog
window. Refer to Figure 5-7.
4. Touch the Accept (checkmark) button.
Operating Limits -
Basic
Select the user role that can change the basic operation limit fields when
servo equipment is installed on the Altanium controller.
Operating Limits -
Advanced
Select the user role that can change the advanced operation limit fields
when servo equipment is installed on the Altanium controller.
I/O Signal Interface Select the user role that can change the input and output interface fields
when servo equipment is installed on the Altanium controller.
Motion Profile Select the user role that can change the motion profile fields when servo
equipment is installed on the Altanium controller.
Permissions Select the user role that can assign permissions for servo operation fields
when servo equipment is installed on the Altanium controller.
Equipment
Protection
Select the user role that can change the Equipment Protection options on
the System Setup (Main tab): Air Filter and Servo Cabinet Internal
Temperature
Table 5-6 Screen Security - Servo Screen (Continued)
Item Description
To Next Page
Loading...
Need help?
General
