Husky Altanium Matrix5 User Manual

User Guide v 1.0 — February 2020 Mold Picture View
Mold Picture View Graphic 147
Chapter 11 Mold Picture View
This chapter describes how to use the mold picture view.
11.1 Mold Picture View Graphic
You can load a mold picture view graphic from one of the sources that follow:
• Local drive
• USB drive
• Network
With a picture of the mold loaded, you can add information panels to the picture that identify
the zones. Each panel contains a zone number and two items of information that you can
select. Refer to Section 11.3.2.3 to see the selections.
11.1.1 Map a Network Drive
If you load a mold picture view graphic from the network, make sure the Altanium is mapped
to the correct network drive.
To map a network drive, do the steps that follow:
1. On the Home screen, touch the System Setup button.
2. Touch the Network tab.
3. Touch the Location field and then type the network location.
4. Touch the Accept button.
5. Touch the Domain Name field and then type the domain name.
6. Touch the Accept button.
7. If necessary, touch the User Name and Password fields and enter the applicable
information.

Husky Altanium Matrix5 Specifications

General

Brand	Husky
Model	Altanium Matrix5
Category	Controller
Language	English