Save the Current Mold Setup File as a New File 49
User Guide v 1.0 — February 2020 Mold Setups
6.1.5 Save the Current Mold Setup File as a New File
when a Mold Setup file has been loaded, it can be saved as a new file.
To save the loaded Mold Setup file as a new file, do the steps that follow:
1. On the Mold Setup screen, touch the Save As button. The Mold Setup - SaveAs dialog
box shows, so you can make sure that the mold and new name of the file are correct.
2. Touch the Accept button.
6.1.6 Load an Existing Mold Setup File
After a Mold Setup file is made, it is automatically loaded as the Mold Setup in the system.
To load a different Mold Setup, do the steps that follow:
1. On the Mold Setup screen, select the Mold Setup folder that contains the Mold Setup file
to be loaded.
2. Touch the name of the mold setup file to be loaded.
3. Touch the Load Mold Setup button to load the selected mold setup.
After a mold setup is loaded, its name will be shown at all times on the Mold Setup Info
button in the System Footer.
6.1.7 Delete Files
When it is not necessary to keep a file or folder on the internal disk, it can be deleted.
To delete a file or folder, do the steps that follow:
1. On the Mold Setup screen, touch the file or folder to be deleted.
2. Touch the Delete button.
3. A message shows that asks you to confirm the deletion. To continue, touch the Accept
button. To cancel the deletion, touch the Cancel button.
6.1.8 Copy Files
Mold setups, images, documents, or notes can be copied from one folder or device to a
different folder. Only files from folders with the same name or type can be copied into that
folder. For example, a mold setup file can be pasted only into a mold setup folder.
To copy and paste a file, do the steps that follow:
1. On the Mold Setup screen, touch the file to be copied.
2. Touch the Copy button.
A Files - Copy dialog window shows.
3. Touch the Accept button.
To Next Page
Loading...
Need help?
General
