OPERATING CONTROLS AND FEATURES GRT9165 OPERATOR MANUAL
3-36 Published 7-23-2020, Control # 668-02
Swing Brake Pedal
The Swing Brake Pedal (1, Figure 3-26) is located on the left
side of the cab floor.
Push Swing Brake Pedal to slow and stop the swing motion.
Braking increases or decreases proportionately with the
amount of foot pressure applied to the pedal.
Service Brake Pedal
The Service Brake Pedal (2, Figure 3-26) is the second
pedal from the right on the cab floor.
Push Service Brake Pedal to apply the service brakes.
Braking increases or decreases proportionately with the
amount of foot pressure applied to the pedal.
NOTE: Crane must be stopped and service brake pedal
pushed and held before changing between
transmission drive modes (two-wheel drive and
four-wheel drive) (refer to Drive Axle Selector
Switch, page 3-7).
Crane must be stopped and service brake pedal
pushed and held before the driving controls can be
reversed (refer to Steering Reversal Switch, page
3-14).
Throttle Pedal
The Throttle Pedal (3, Figure 3-26) is located on the right
side of the floor.
Push Throttle Pedal to increase the engine speed.
Engine speed increases or decreases proportionately with
the amount of foot pressure applied to the pedal.
Floor Mat
A Floor Mat (4, Figure 3-26) is provided to make cleaning the
cab floor easier.
When dirty, remove floor mat from cab. Clean using water
and a soft bristle brush.
Before operating the crane, make sure that the floor mat is in
the correct position and does not interfere with the operation
of the foot pedals.
To Next Page
Loading...
Need help?
General
