Grove Published 7-23-2020, Control # 668-02 4-65
GRT9165 OPERATOR MANUAL OPERATING PROCEDURES
Table 4-5 – Boom Lift Function Screen
Boom Lift
See Figure 4-65
1. Press the boom lift button on the remote control
unit. The boom lift screen (1) appears.
NOTE: Speed in either direction is proportional to how far
the motion button is pressed.
2. To LOWER the boom, hold down either enable button
and the left motion button at the same time. Release
both buttons to stop the boom.
3. To RAISE the boom, hold down either enable button and
the right motion button at the same time. Release both
buttons to stop the boom.
4. The boom’s angle is shown in the DEG screen (5).
5. To exit this screen, press the ESC button on the
remote control unit. The main screen appears.
Item Indicator Name Description
1 Boom Lift Function 1 - Green = boom can be operated
2 Boom Down
2a - White = boom cannot be operated until either enable button is held down
2b - Green = boom can be lowered with left motion button
3Boom Up
3a - White = boom cannot be operated until either enable button is held down
3b - Green = boom can be raised with right motion button
4 Enable Button Status
7a - White = both enable buttons released (operation disabled)
7b - Green = either enable button held down (operation enabled)
5 DEG Screen Shows the boom angle in degrees
To Next Page
Loading...
Need help?
General
