Grove Published 7-23-2020, Control # 668-02 3-23
GRT9165 OPERATOR MANUAL OPERATING CONTROLS AND FEATURES
Swing Brake Engaged Indicator
The Swing Brake Engaged Indicator (8, Figure 3-14) is
located immediately below and to the right of the ODM
screen.
The swing brake engaged indicator comes on (amber) when
the swing brake is applied. The indicator goes off when the
swing brake is released.
The swing brake is automatically released when the swing
controller is actuated. The swing brake is automatically
applied when the superstructure stops rotating.
Brightness Sensor
A Brightness Sensor (9, Figure 3-14) is located immediately
below and to the right of the RDM screen and ODM screen.
The Brightness Sensors sense the amount of light in the
operator cab. As the amount of light inside the cab changes,
the RDM screen and the ODM screen will brighten and
darken automatically, making the screens easier for the
operator to see.
Internal Temperature Warning Indicator
An Internal Temperature Warning Indicator (10, Figure 3-14)
is located immediately below and to the right of the RDM
screen and ODM screen.
When the Ignition Switch is turned to the RUN (I) position
and the internal temperature of either the RDM or the ODM is
below -30°C (-22°F), the related module Internal
Temperature Warning Indicator will come on (blue) and the
module screen will remain blank.
When the ignition switch is turned to the position and the
internal temperature of either the RDM or the ODM is above
70°C (158°F), the related module Internal Temperature
Warning Indicator will come on (red) and the module screen
will remain blank.
For the RDM and ODM screens to come on, their internal
temperatures must be between -30°C (-22°F) and 70°C
(158°F).
To Next Page
Loading...
Need help?
General
