MAINTENANCE AND LUBRICATION GRT9165 OPERATOR MANUAL
6-38 Published 7-23-2020, Control # 668-02
Item
Lube Point
Description
Figure No.
Approved
Lubricant
Approximate
Capacity
Service Interval
Service
Application
Boom Lubrication (Continued)
41
Telescopic
Slide Faces
See NOTE 45.
Figure 6-19 N BRUSH ON
Every 500 hours, or
6 months, whichever
interval comes first
BRUSH ON front
faces in a thin line
See NOTE 46.
NOTE 45: DO NOT USE non semi-synthetic lubricant. Use of non-approved lubricant may damage components.
NOTE 46: Extend boom for access to telescopic slide front faces that contact wear pads inside the boom. Follow the
boom Tele Section positioning and lubrication instruction given in the section titled READ FIRST! IMPORTANT
CRANE SET-UP INFORMATION!, page 6-36. If the weather is very bad or operating conditions are poor, then
more frequent intervals are necessary. Monitor the service points and adjust lubrication intervals, as necessary.
CAUTION
Possible Equipment Damage!
Use semi-synthetic or synthetic lubricants as listed in Section 6 of this Operator Manual. See
also your Service Manual for maintenance and lubrication instructions. Use of non-approved,
non semi-synthetic lubricant may damage components and/or invalidate published lubricant
intervals. Failure to follow this instruction may cause damage to equipment.
To Next Page
Loading...
Need help?
General
