Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-54 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
CLR PROGRAM
Description: Clears the specified control program line.
Command Level: 5
Syntax: CLR PROGRAM
CLR PROGRAM F[channel_number]
CLR PROGRAM L[channel_number]
CLR PROGRAM R[node_number_channel_number]
CLR PR
CLR PR F[channel_number]
CLR PR L[channel_number]
CLR PR R[node_number_channel_number]
Comments: This command clears from memory the control program line of the function
channel, LED channel, or relay channel specified. This command also recompiles the
remaining control program lines. If a specific control program line is not entered, the
system prompts for an entry.
Notes: Can be used to erase an invalid control program line that was detected during an
upload procedure, and to recompile the remaining valid control program lines.
Related Commands: none
Example:
Command<5>: CLR PROG
Which channel? R0001
CONTROL PROGRAM:
R0001=B0001
Clear program line for channel R0001? (Y or N): Y

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English