Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-159
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET CMD
Description: Permits configuration of one of the eight programmable commands.
Command Level: 6
Syntax: SET CMD [n]
SE CM [n]
Comments: Each command can consist of up to eight standard commands. When the
command SET CMD is entered, the system prompts for the number of the programmable
command the user wishes to configure. The system then prompts the user to enter the
commands which will comprise the programmable command as well as the name of the
programmable command. The name is then used at the system prompt to execute these
standard commands that are a part of the programmable command. When the name of
the programmable command is entered, all of the commands listed in the group are
automatically performed, without having to manually prompt the system to perform each
task.
Notes: Any commands entered as part of the programmable command will not be
executed if the logged on user does not have a high enough level of access. The use of
the programmable command is similar in concept to batch processing or macros.
Related Commands: CMD
Example:
Command<6>: SET CMD
1.
2.
3.
4.
5.
6.
7.
8.
Which command (1 - 8) ? 1
Command 1 name:
Command 1 name: ANALOG
Command 1 access level: 1
Command 1 access level:
Command 1 line 1:
Command 1 line 1: SCAN A
Command 1 line 2:
Command 1 line 2: STATS A
Command 1 line 3:
Command 1 line 3:
Command 1 line 4:
Command 1 line 4:

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English