Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-106 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
NODE ADD
Description: Adds to the database all new nodes found on the network, and then allows
the nodes to be configured.
Command Level: 6
Syntax: NODE ADD
NO AD
Comments: The system searches for new nodes on the network and then lists all nodes
(new and old) by Node#, Name, Spec. Number, Ser.# (serial number), Loc (location), and
Echelon Id #. The system prompts the user to select a node to configure. You select the
node by entering the Node# from the list. Note that the node numbers for unmapped
nodes (nodes that were not previously configured) are temporarily listed as X01 through
X99 for reference. Once a node is selected by it’s number, the user configures the node
as explained under the NODE CONFIGURE command.
Notes: Use of this command generates an entry in the Event Log. The Main Cabinet,
VPS MCA Interface, and LPS MCA Interface Nodes are automatically added to the
system by other mechanisms, and are not shown in the list.
"IO network is running." is displayed when the network is ready. The follow are displayed
if the network is not ready.
"IO network is adding nodes.
IO network commands not ready!"
Indicates a new IO network is being discovered.
"IO network is verifying nodes.
IO network commands not ready!"
Indicates a known network is being verified.
"IO network is failed.
IO network commands not ready!"
Indicates an IO network has failed and no communication to nodes is possible.
"IO network is not initialized.
IO network commands not ready!"
Only displayed for a very short time after a reset.
"IO network state is undefined!
IO network commands not ready!"
Only displayed for a very short time after a reset on a new system.
Related Commands: NODE CONFIG, NODE DELETE, NODE LIST, NODE REPLACE
Example:
Command<6>: NODE ADD
IO network is running.
Searching for new nodes
To Next Page
Loading...
Need help?
General
