Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-182 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS MESSAGE RELAY
Description: Sets the Custom Text Message for the selected LPS Relay element. This
message appears in the inventory list during execution of the PRCONFIG LPS command.
A user can also view the Custom Text Message from the MCA display panel whenever
the i (information available) symbol appears in the display. Refer to the LPS System
documentation.
Command Level: 6
Syntax: SET LPS MESSAGE RELAY
SE LP ME RE
Comments: The current message is displayed, followed by a prompt to enter a new
message.
Notes: The custom message can be 20 characters, maximum.
Related Commands: none
Example:
Command<6>: set lps mes rel
Which relay board (bay#-board#)? 01-07
Relay board 01-07 not found!
___________________________________________________________________________________
Command<6>: set lps mes rel
Which relay board (bay#-board#)? 01-01
Which message?
Enter 0 for relay board or 1-6 for individual relay # 1
Custom message: XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
Custom message: this is relay 1
Custom message CHANGED!
___________________________________________________________________________________
Command<6>: set lps mes rel
Which relay board (bay#-board#)? 01-02
Which message?
Enter 0 for relay board or 1-6 for individual relay # 0
Custom message: XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
Custom message: this is board 2
Custom message CHANGED!
To Next Page
Loading...
Need help?
General
