User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-213
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS SYSTEM VERYLOWVOLT
Description: Sets the LPS "very low voltage alarm" value.
Command Level: 5
Syntax: SET LPS SYSTEM VERYLOWVOLT
SE LP SY VE
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Not Changed!
Related Commands: none
Example:
Command<6>: set lps sys very
Very Low Voltage Alarm: 47.00 VDC
Very Low Voltage Alarm: 47.1
New Very Low Voltage Alarm Accepted.
To Next Page
Loading...
Need help?
General
